Before you avail of water jet cutting services, you should know what it entails. A water jet cutter can be described as a machine that can cut through a wide range of materials. This includes materials that vary widely in terms of thickness. It does so by using water at high pressure and mixing it with garnet, which is fine grit. When it comes to comparison, it is just the same as erosion caused by natural water. It is just that here the end product is refined to a stream that has high pressure and is finer by nature.
The stream of water that is used in the context of water jet cutting services is around 0.8 mm in terms of thickness. It also runs via a nozzle at 40,000 PSI (pound per square inch).
The benefits of using a water jet cutter
There are several reasons why you should use such a machine. First of all, these are highly accurate machines that we are talking about over here. They can be accurate at a range between 0.1 mm and 0.3 mm. This depends on how thick the material in question is. With this machine, you would be able to cut almost any material.
Some more benefits of these machines
With the help of water jet cutting services, you would be able to cut materials that are between 0.5 mm and 90 mm in thickness. These machines do not generate any heat. At the same time, you can rule out burn marks with them as well. They are fully capable of cutting through composite materials such as honeycomb sheets. They can also cut a wide range of shapes that are intricate by nature. Since they have streams in the range of 0.8 mm not a lot of waste is generated in these cases. Once you have cut something with such a machine you would have to do minimal work in removing the burrs.
How are they better than laser cutting?
There are many ways in which water jet cutting services are better than laser cutting. First of all, there is very little burr generated thanks to heat transference. In these cases, you do not have any warping. This is because the material here is being cold cut. You do not get any heat over here. Since there is no heat over here the material being cut does not experience any change at the structural level. It can cut a lot of materials that cannot otherwise be cut by using a laser.
Conclusion
This includes the likes of reflective materials, composite materials, and die cut gaskets. When it comes to the thicker materials the water jet cutters offer a far better level of tolerance. They also leave clean edges. This makes it easier for you to do welding work should such need arise. It also does not need a lot of time to do your cutting with these. This is because the parts over here do not need clamping pressure as such.
It also helps that these products are good for the environment. This is because they do not leave any fumes or gases as such.
